SD UHS-I micro SD to SD FPC Cable

Brand name: ADT-LINK

Product name: SD UHS-I micro SD to SD FPC Cable

Product model: B19 series

Transfer speed: support of increased bandwidth up to UHS-I 104MB/s (Max.)

Product application: GPS navigator, hard disk, ROCK Pi 4 Raspberry Pi MCU development board, built-in micro SD connector to extension SD card.

Procurement Tips: Be sure to buy 1~2 samples first and then purchase in bulk after testing and verifying that they are correct.

Purchase restriction: This product is designed to be connected to the built-in SD device and is limited to the product engineer's designated purchase. Individual buyers are not allowed to place an order for purchase. It is not easy to use for ordinary purposes, and returns and exchanges are not supported. Please consider carefully before placing an order for purchase

Product List:

Cable length Description:

The length of the wire refers to the part of the FFC visible wire. Please refer to the arrow in the figure below.

Q&A:

UHS-I Extender cable Test:

The dotted line is the speed measurement of UHS-I high-speed card, the theoretical value is 104MB/s, and the measured speed is about 95MB/s

The compatibility of the SD extension cable is related to the cable length. The cable length is less than 30cm and supports UHS-I 104MB/Sec full speed. The cable length is more than 30cm and only supports ordinary SD cards without the "I" character. The SD cards will have a speed mark. As shown below

Does it support hot swap?

Hot plugging is not supported. You need to shut down the device before installing the SD extension cable.

Does it support UHS-II, III SD cards?
It can be used, but it can only play the performance of UHS-I, not full speed

Download:

To open 3D PDF files. Please use Adobe Reader DC software.

FTP: Los Angeles

3D model STEP & PDF files download: http://www.adt.link/download/SDEXT.ZIP

FTP: Hong Kong

3D model STEP & PDF files download: http://www.adtlink.cn/download/SDEXT.ZIP

WebShop:

http://www.adt.link/product/B19-Shop.html